[17:51:13] Loading simulator. [17:51:13] Loading driver: replicatorg.drivers.gen3.Sanguino3GDriver [17:52:55] Loading /home/andreas/Downloads/replicatorg-0040/examples/Snake.stl [17:52:57] /home/andreas/Downloads/replicatorg-0040/examples/Snake.stl [17:53:03] Connecting to machine using serial port: /dev/ttyUSB0 [17:53:03] Motherboard firmware v2.3 (Cupcake) [17:53:03] Toolhead 0: Not found. Make sure the toolhead is connected, the power supply is plugged in and turned on, and the power switch on the motherboard is on. [17:53:03] ******************************************************** This version of ReplicatorG is not reccomended for use with firmware before version 3.0. Either update your firmware or proceed with caution. ******************************************************** [17:54:34] Packet response code: Unknown code [17:54:34] Packet payload: empty [17:55:11] On tool read: Unknown code [17:55:11] readFromToolEEPROM null12 2 0 [17:55:11] null read from tool at 12 for tool 0 default 7.0 [17:55:11] On tool read: Unknown code [17:55:11] readFromToolEEPROM null14 2 0 [17:55:11] null read from tool at 14 for tool 0 default 0.325 [17:55:12] On tool read: Unknown code [17:55:12] readFromToolEEPROM null16 2 0 [17:55:12] null read from tool at 16 for tool 0 default 36.0 [17:59:51] Connecting to machine using serial port: /dev/ttyUSB0 [17:59:51] Motherboard firmware v2.3 (Cupcake) [17:59:51] Toolhead 0: Extruder controller firmware v2.5 () [17:59:51] ******************************************************** This version of ReplicatorG is not reccomended for use with firmware before version 3.0. Either update your firmware or proceed with caution. ******************************************************** [18:23:23] Loading simulator. [18:23:23] Loading driver: replicatorg.drivers.gen3.Sanguino3GDriver [18:23:26] Connecting to machine using serial port: /dev/ttyUSB0 [18:23:26] Motherboard firmware v3.0 () [18:23:26] Toolhead 0: Extruder controller firmware v2.5 () [20:11:43] Loading simulator. [20:11:43] Loading driver: replicatorg.drivers.gen3.Sanguino3GDriver [20:11:43] Connecting to machine using serial port: /dev/ttyUSB0 [20:11:43] Motherboard firmware v3.0 () [20:11:43] Toolhead 0: Extruder controller firmware v3.0 (Extruder
ReplicatorG
Leave a reply